M-LOK LONGBOY HANDGUARD, Vz.58

Preorder- were collecting first round of orders before staring production in August. There's 20% off till then.

Long CNC handguard made of 7075 aluminum alloy with hard anodizing designed for Vz. 58 rifles with a standard barrel length of 390 mm.

Another part from the Gundocthor project, again significantly redesigned.

The handguard has 40mm width and it is mounted to the barrel right in front of the gas block. You'll find more than enough M-Lok slots on all eight sides of the handguard to mount any accesories you need. These slots also help air flow for better barrel cooling.

The upper part is equipped with a low-profile ten-groove picatinny rail, which is fully embedded in the contour of the handguard. This improves the ergonomics of the grip and does not interfere with the sight picture. The picatinny rail is positioned close to the barrel axis, allowing for the installation of a small red dot (like Aimpoint T1) while providing a good view of the mechanical sights through the red-dot. Thanks to the set screws, the upper part of the handguard does not move and thus holds perfect zero even after repeated removal and reattachment of the handguard. To keep the monolithic design, we have reinforced the forks at the front (see photo 3), making them much more resistant to heat during sustained firing.

On the sides, you will again find three full M-LOK slots for attaching additional accessories. Their higher placement does not interfere with a comfortable grip.

With this handguard without compromise, your rifle can match even the most up-to-date weapons.

The photos show renderings and a 3D-printed prototype.